ADJTIMEX(2) Linux Programmer's Manual ADJTIMEX(2)


adjtimex - tune kernel clock


#include <sys/timex.h>
int adjtimex(struct timex * buf );


Linux uses David L. Mills' clock adjustment algorithm (see RFC 1305). The system call adjtimex() reads and optionally sets adjustment parameters for this algorithm. It takes a pointer to a timex structure, updates kernel parameters from field values, and returns the same structure with current kernel values. This structure is declared as follows:

struct timex {
int modes; /* mode selector */
long offset; /* time offset (usec) */
long freq; /* frequency offset (scaled ppm) */
long maxerror; /* maximum error (usec) */
long esterror; /* estimated error (usec) */
int status; /* clock command/status */
long constant; /* pll time constant */
long precision; /* clock precision (usec) (read-only) */
long tolerance; /* clock frequency tolerance (ppm)
(read-only) */
struct timeval time; /* current time (read-only) */
long tick; /* usecs between clock ticks */

The modes field determines which parameters, if any, to set. It may contain a bitwise- or combination of zero or more of the following bits:

#define ADJ_OFFSET 0x0001 /* time offset */
#define ADJ_FREQUENCY 0x0002 /* frequency offset */
#define ADJ_MAXERROR 0x0004 /* maximum time error */
#define ADJ_ESTERROR 0x0008 /* estimated time error */
#define ADJ_STATUS 0x0010 /* clock status */
#define ADJ_TIMECONST 0x0020 /* pll time constant */
#define ADJ_TICK 0x4000 /* tick value */
#define ADJ_OFFSET_SINGLESHOT 0x8001 /* old-fashioned adjtime() */

Ordinary users are restricted to a zero value for mode. Only the superuser may set any parameters.



On success, adjtimex() returns the clock state:

#define TIME_OK 0 /* clock synchronized */
#define TIME_INS 1 /* insert leap second */
#define TIME_DEL 2 /* delete leap second */
#define TIME_OOP 3 /* leap second in progress */
#define TIME_WAIT 4 /* leap second has occurred */
#define TIME_BAD 5 /* clock not synchronized */

On failure, adjtimex() returns -1 and sets errno.


buf does not point to writable memory.
An attempt is made to set buf.offset to a value outside the range -131071 to +131071, or to set buf.status to a value other than those listed above, or to set buf.tick to a value outside the range 900000/ HZ to 1100000/ HZ, where HZ is the system timer interrupt frequency.
buf.mode is nonzero and the caller does not have sufficient privilege. Under Linux the CAP_SYS_TIME capability is required.


adjtimex() is Linux-specific and should not be used in programs intended to be portable. See adjtime(3) for a more portable, but less flexible, method of adjusting the system clock.


settimeofday(2), adjtime(3), capabilities(7), time(7)


This page is part of release 3.53 of the Linux man-pages project. A description of the project, and information about reporting bugs, can be found at http://www.kernel.org/doc/man-pages/.
2004-05-27 Linux