QLXGB(4) | FreeBSD Kernel Interfaces Manual | QLXGB(4) |
NAME
qlxgb — QLogic 10 Gigabit Ethernet & CNA Adapter DriverSYNOPSIS
To compile this driver into the kernel, place the following lines in your kernel configuration file:
device qlxgb
To load the driver as a module at boot time, place the following line in loader.conf(5):
if_qlxgb_load="YES"
DESCRIPTION
The qlxgb driver supports IPv4 checksum offload, TCP and UDP checksum offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling. For further hardware information, see http://www.qlogic.com/.HARDWARE
The qlxgb driver supports 10 Gigabit Ethernet & CNA Adapter based on the following chipsets:
- QLogic 3200 series
- QLogic 8200 series
SUPPORT
For support questions please contact your QLogic approved reseller or QLogic Technical Support at http://support.qlogic.com, or by E-mail at <support@qlogic.com>.HISTORY
The qlxgb device driver first appeared in FreeBSD 10.0.AUTHORS
The qlxgb driver was written by at QLogic Corporation.November 3, 2011 | FreeBSD |