|MQ_CLOSE(3P)||POSIX Programmer's Manual||MQ_CLOSE(3P)|
PROLOGThis manual page is part of the POSIX Programmer's Manual. The Linux implementation of this interface may differ (consult the corresponding Linux manual page for details of Linux behavior), or the interface may not be implemented on Linux.
NAMEmq_close - close a message queue ( REALTIME)
DESCRIPTIONThe mq_close() function shall remove the association between the message queue descriptor, mqdes, and its message queue. The results of using this message queue descriptor after successful return from this mq_close(), and until the return of this message queue descriptor from a subsequent mq_open(), are undefined.
If the process has successfully attached a notification request to the message queue via this mqdes, this attachment shall be removed, and the message queue is available for another process to attach for notification.
RETURN VALUEUpon successful completion, the mq_close() function shall return a value of zero; otherwise, the function shall return a value of -1 and set errno to indicate the error.
ERRORSThe mq_close() function shall fail if:
mqdes argument is not a valid message queue descriptor.
The following sections are informative.
SEE ALSOmq_open(), mq_unlink(), msgctl(), msgget(), msgrcv(), msgsnd(), the Base Definitions volume of IEEE Std 1003.1-2001, <mqueue.h>
COPYRIGHTPortions of this text are reprinted and reproduced in electronic form from IEEE Std 1003.1, 2003 Edition, Standard for Information Technology -- Portable Operating System Interface (POSIX), The Open Group Base Specifications Issue 6, Copyright (C) 2001-2003 by the Institute of Electrical and Electronics Engineers, Inc and The Open Group. In the event of any discrepancy between this version and the original IEEE and The Open Group Standard, the original IEEE and The Open Group Standard is the referee document. The original Standard can be obtained online at http://www.opengroup.org/unix/online.html .
|2003||IEEE/The Open Group|