QLXGE(4) | FreeBSD Kernel Interfaces Manual | QLXGE(4) |
NAME
qlxge — QLogic 8100 Series 10 Gigabit Ethernet Adapter DriverSYNOPSIS
To compile this driver into the kernel, place the following lines in your kernel configuration file:
device qlxge
To load the driver as a module at boot time, place the following line in loader.conf(5):
if_qlxge_load="YES"
DESCRIPTION
The qlxge driver supports IPv4 checksum offload, TCP and UDP checksum offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling. For further hardware information, see http://www.qlogic.com/.HARDWARE
The qlxge driver supports 10 Gigabit Ethernet & CNA Adapter based on the following chipsets:
- QLogic 8100 series
SUPPORT
For support questions please contact your QLogic approved reseller or QLogic Technical Support at http://support.qlogic.com, or by E-mail at <support@qlogic.com>.HISTORY
The qlxge device driver first appeared in FreeBSD 10.0.AUTHORS
The qlxge driver was written by at QLogic Corporation.June 21, 2013 | FreeBSD |