NAME

qlxge — QLogic 8100 Series 10 Gigabit Ethernet Adapter Driver

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file:

To load the driver as a module at boot time, place the following line in loader.conf(5):

if_qlxge_load="YES"

DESCRIPTION

The qlxge driver supports IPv4 checksum offload, TCP and UDP checksum offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling. For further hardware information, see http://www.qlogic.com/.

HARDWARE

The qlxge driver supports 10 Gigabit Ethernet & CNA Adapter based on the following chipsets:

• QLogic 8100 series

SUPPORT

For support questions please contact your QLogic approved reseller or QLogic Technical Support at http://support.qlogic.com, or by E-mail at <support@qlogic.com>.

SEE ALSO

altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)

HISTORY

The qlxge device driver first appeared in FreeBSD 10.0.

AUTHORS

The qlxge driver was written by David C Somayajulu at QLogic Corporation.