EN JA
MALO(4)
MALO(4) FreeBSD Kernel Interfaces Manual MALO(4)

NAME

maloMarvell Libertas IEEE 802.11b/g wireless network driver

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file:

device malo
device pci
device wlan
device firmware

Alternatively, to load the driver as a module at boot time, place the following lines in loader.conf(5):

if_malo_load="YES"

DESCRIPTION

The malo driver provides support for Marvell Libertas 88W8335 based PCI and Cardbus network adapters. malo supports station and monitor mode operation. Only one virtual interface may be configured at any time. For more information on configuring this device, see ifconfig(8).

This driver requires the malofw firmware kernel module be installed before it will work. The firmware files are not publicly available. A port of the firmware can be found at:

http://weongyo.org/project/malo/malo-firmware-1.4.tar.gz

The firmware kernel module can be installed by extracting the archive and running ‘ make install clean’ in the malo-firmware-1.4 directory.

HARDWARE

The following cards are among those supported by the malo driver:
Card Chip Bus Standard
Netgear WG311v3 88W8335 PCI b/g
Tenda TWL542P 88W8335 PCI b/g
U-Khan UW-2054i 88W8335 PCI b/g

EXAMPLES

Join an existing BSS network (i.e., connect to an access point):

ifconfig wlan create wlandev malo0 inet 192.168.0.20 \ 
    netmask 0xffffff00

Join a specific BSS network with network name “ my_net”:

ifconfig wlan create wlandev malo0 ssid my_net up

Join a specific BSS network with 64-bit WEP encryption:

ifconfig wlan create wlandev malo0 ssid my_net \ 
 wepmode on wepkey 0x1234567890 weptxkey 1 up

HISTORY

The malo device driver first appeared in FreeBSD 7.1.
October 21, 2009 FreeBSD